Hub Stand PLUS Production Examples
Here are some examples of the Hub Stand PLUS we have manufactured, presented with actual photos and CAD dimension drawings.
For each example, you can see the dimensions and design innovations. You can also order the same specifications by specifying the contents of the specification table and writing "Same specifications as production example XX" in the remarks column.
Porsche 911 / AE86
This example was made specifically for Porsche 911 and AE86 models.
It is manufactured with a PCD of 130/5 holes (M14) and a black finish.
Additionally, a PCD 114.3/4 hole specification is also available for conversion.
Even for vehicles like Porsche, where the front and rear tire diameters differ, the height (length) of the Hub Stand PLUS can be adjusted to enable more precise alignment measurements under conditions close to those of the actual vehicle.
Furthermore, by using the hub stand in conjunction, it is compatible with the AE86, allowing for a consistent measurement environment across different vehicle types.
Specifications Table
PCD | 130 |
|---|---|
Number of holes | 5. Hub bolt M14 |
Ground to hub center height | Front: 316.0 |
PCD | 114.3 |
|---|---|
Number of holes | 4 |
Ground to Hub Center Height | 303.0 |
Impreza
This example was made for the Impreza.
Specifications are PCD 114.3 / 5 holes, silver color .
Specifications
PCD | 114.3 |
|---|---|
Number of holes | 5 |
Ground to Hub Center Height | 345mm |
Subaru BRZ (ZD8)
This example was made for the Subaru BRZ (ZD8).
The specifications are PCD100/5-hole, silver color .
Specifications table
PCD | 100 |
|---|---|
Number of holes | 5 |
Ground to hub center height | 313.5mm |
Wheel diameter in inches | 16-18 inches |
Remarks | Toe Adjustment Tool |
Nissan Skyline GT-R (BNR32 / BCNR33 / BNR34)
This product was manufactured for the Nissan Skyline GT-R (BNR32/BCNR33/BNR34).
The specifications are PCD114.3 / 5-hole, silver color . The toe adjustment tool was manufactured for 16-18 inch compatibility.
Specifications Table
PCD | 100 |
|---|---|
Number of holes | 5 |
Ground to hub center height | 313.5mm |
Wheel size | 16-18 inches |
Remarks | Tone Adjustment Tool |
Hub Stand PLUS
Hub Stand
TECHNICAL GUIDE
製品選びから測定環境の構築まで、設計・製造の視点から解説します。
FEATURE GUIDE
アライメントツールは、測定基準をどう作っているのか
加工方法と形状管理から、
製品ごとの設計意図を解説します。
GUIDE 01
ダミーホイールとは？
できること・できないこと、一般的なホイールとの違いを解説します。
GUIDE 06
ダミーホイールとハブスタンドPLUSの違い
構造、仕様自由度、重量、価格から、用途に合う製品を比較します。
仕様を確認する
選ぶときに確認したい7つの項目
ハブ中心高さを決める方法
測定結果を左右する、基準・剛性・測定条件