Hub Stand 2-piece set

Product Use

- Useful for 1G tightening when replacing suspension, supporting the axle when overhauling the suspension, and adjusting the spring preload on torsion beam vehicles.

Basic Specifications

- Set of 2 - Hub center diameter: Φ73.1 (commercially available hub rings can be installed)
- Product length (distance from hub center to ground surface)
Please specify a value between 70 and 350 mm.

Mounting Type

・PCD 100/112.5/114.3/120/130
・Number of holes: 4 or 5
*Other sizes are also available, so please contact us for details.

Color variations

・Silver (trivalent chromate)
・Black (iron oxide coating)

Supported loads and their conditions

- Design load: Maximum 500kg per sheet
- Compatible camber angle: up to 10 degrees

Shipping and Orders

Since this is a made-to-order product, it will take approximately one month from order and payment to shipping. If you are in a hurry, please order well in advance.

Other notes

- Do not use to support vehicles for long periods of time.
- There may be oil on the surface, but this is an anti-rust treatment and we do not recommend removing it.
- When using all four wheels at the same time, hold the vehicle body on a rigid rack and support only the front and rear axle housings with this product.